The CNC horizontal milling machine is composed of various parts, such as the body, the main drive, the lifting table, the worktable, the suspension beam, lubrication and the electrical. The fuselage is composed of a base and a bed, and the bed is fixed in on the base; The main drive is installed in the bed and transmitted to the tool holder shaft through the pulley; The lifting platform and the bed have a linear rail to cooperate, and it is vertically lifted along the guide rail of the bed; Lifting tables and slides By rectangular guide rail, workbench and slide are matched by linear rail, and workbench is driven to move longitudinally and transversely by lead screw, wire mother; The cantilever part has a fixed seat, a ram, and a hanger composition, the fuselage body is mounted on the top of the fixed seat, and the ram is matched by a line rail, and the pylons are hung at the other end of the ram; The coolant is stored in the inner cavity of the base; Lubricate the main drive The door is forced to lubricate by a lubricating oil pump, and the rest of the moving parts are lubricated by a lubricating oil pump at a fixed point; The electrical box is fixed outside the bed, and the electrical control operation controls the left side of the lifting table respectively side, the right side of the bed or supported by the cantilever bracket in front of the left side of the foundation, easy to operate.

Operation

1. Before operation, wear tight-fitting protective clothing, the cuffs are fastened, the hem of the jacket cannot be opened, and gloves are strictly prohibited.Do not change, take off or change clothes next to the machine tool that is running, or wrap around the body to prevent the machine from being strangled.You must wear a safe song, put the argument in the singing, and do not wear skirts and slippers.Wear protective goggles: in case of splashing of iron filings, and install a baffle around the machine to isolate it from the operating area.

2. Before the workpiece is clamped, the clamping method should be formulated. When clamping blanks, the table top should be padded to avoid damage to the workbench.

3. Check that the fastening screws should be opened when the workbench moves, and the fastening screws should be tightened when the workbench does not move.

4. When the cutter is loaded and unloaded, the cone part of the milling cutter and the taper hole should be kept clean, and the clamping should be firm.Protective goggles must be worn when cutting at high speeds.The workbench is not allowed to stack tools, parts and other objects, pay attention to the distance between the tool and the workpiece to prevent impact accidents.

5. Before installing the milling cutter, check whether the cutter is in good condition and the milling cutter should be installed as close to the spindle as possible, and test run after installation.The mounting workpiece should be fixed on the car.